EDM Solution 862, Installation Manual

Page: 107 / 262

System Functions 107
Hold Down Functions
Hold down functions have been incorporated to allow easy activation of specific operations.
When a button is held down for two seconds, two beeps will be heard and a particular function
will operate. The hold down functions available are listed below.
Arm The System In AWAY Mode
# Holding the
#
button down until two beeps are heard will arm the system in AWAY Mode.
Option 2 in "LOCATION 429" on page 220 will need to be enabled for this hold down
function to operate.
Arm The System In STAY Mode 1
*
Holding the
*
button down until two beeps are heard will arm the system in STAY Mode 1.
Option 2 in "LOCATION 429" on page 220 will need to be enabled for this hold down
function to operate.
If there has not been an alarm during the armed cycle, holding the
*
button down a second
time will disarm the system from STAY Mode 1. If you require single button disarming from
STAY Mode 1 using this hold down function, Option 4 in "LOCATION 429" on page 220 will
need to be enabled.
If an alarm has occurred or entry warning has triggered, a valid user code will need to be used
to disarm the system.
Refer to Zone Options 2 on page 161 for information on programming each zone to be
automatically isolated in STAY Mode 1.
Arm The System In STAY Mode 2
0
Holding the
0
button down until two beeps are heard will arm the system in STAY Mode 2.
Option 2 in "LOCATION 429" on page 220 will need to be enabled for this function to
operate.
If there has not been an alarm during the armed cycle, holding the
0
button down a second
time will disarm the system from STAY Mode 2. If you require single button disarming from
STAY Mode 2 using this hold down function, Option 4 in "LOCATION 429" on page 220 will
need to be enabled.
If an alarm has occurred or entry warning has been triggered, a valid user code will need to be
used to disarm the system.
Refer to Setting STAY Mode 2 Zones using the Installer Code function on page 85 or Setting
STAY Mode 2 Zones using the Master Code function on page 101 for more information.
Horn Speaker Test
1
Holding the
1
button down until two beeps are heard will sound the horn speaker for a two-
second burst. No other sounding device will sound in this mode.
Electronics Design and Manufacturing Pty Limited ISSUE130