EDM Solution 862, Installation Manual

Page: 18 / 262

18
Solution 862
Installation Manual
Quick Start
The following steps will allow you to use the
Solution 862
control panel with the factory
default values. The default values allow the control panel to communicate in the Contact ID
format. If you are not familiar to programming the
Solution
range of control panels, we
suggest that you first read information contained in the programming section beginning on
page 22.
1. After all wiring has been completed, connect the AC plug pack to the control panel.
Both the
MAINS
and
AWAY
indicators will illuminate. The
MAINS
indicator will
display to indicate that the AC mains supply has been connected. The AWAY indicator
displays that the system is now armed in the AWAY Mode. If any 24 hour zones are
unsealed at the time the system is powered up, the siren, strobe and bell outputs will
activate into alarm and the corresponding zone indicator will flash.
2. Enter the default Master Code
2580
followed by the button to disarm the
system and to reset any alarm that may have occurred during the system power up. The
AWAY
indicator will extinguish to indicate that the system has now been disarmed. If
any zone indicators are flashing, this would indicate that an alarm had occurred on that
zone. If a zone indicator is constantly illuminated, this would indicate that the zone is
unsealed.
3. The back-up battery should now be connected.
4. Enter the factory default Installer Code
1234
followed by the button. Two
beeps will be heard and the
STAY
and
AWAY
indicators will now flash simultaneously
to indicate that you have now entered Installer’s Programming Mode. When entering
Installer’s Programming Mode, you will be automatically positioned at “LOCATION
000”, the beginning of the Primary Telephone Number For Receiver 1.
5. Enter the Primary Telephone Number followed by the Secondary Telephone Number
and the Subscriber ID Number for Receiver 1. Refer to Dialler Information on page
130 for more information.
Remember that when programming a zero in the telephone numbers of Receiver 1 and
Receiver 2, a zero must be programmed as a ten. Programming a zero in the telephone
number will indicate the end of the dialling sequence. A zero must be programmed as a
zero in all other locations other than the telephone numbers for Receiver 1, Receiver 2
and the Call Back Telephone number, unless otherwise stated.
6. Set the time for the test reports if required. Any other programming changes required
may also be made, otherwise the factory default settings will be used. Refer to Test
Reporting Time on page 187 for more information on programming test reports.
7.
Enter Installer’s Command
960
followed by the button to exit Installer’s
Programming Mode. Two beeps will be heard and the
STAY
and
AWAY
indicators will
extinguish. The system has now returned to the disarmed state and is now ready for use.
Refer to Installer’s Programming Commands on page 29 for more information.
8.
Use the Master Code to set the date and time. Refer to Set The Date and Time on page
19 for more information
.
ISSUE130 Electronics Design and Manufacturing Pty Limited