EDM Solution 862, Installation Manual

Page: 81 / 262

System Functions 81
How To Program Telco Arming Sequence - Easy Call Forward (No Answer On)
1. Enter your followed by
3
and the button.
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Press button
1
followed by the button to change the telco arming sequence.
Three beeps will be heard.
If a previous call forwarding sequence has already been programmed, the sequence will
be displayed one digit at a time via the remote codepad indicators. Refer to “Table 29:
Codepad Indicators For Changing Telco Arm/Disarm Sequence” on page 80 for the
indicators and their meanings.
If there is no call forward sequence programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the call
forward sequence has been displayed.
3. Enter
161
followed by the you wish the control panel to divert all
calls to followed by
2
and the button. Two beeps will be heard and the
system will return to the disarmed state.
+
3
+
1
+
161
+ +
2
+
Example
If you wish to automatically divert all unanswered incoming calls to another telephone number
(e.g.: 9672 1777) when the system is armed in AWAY Mode, follow the example sequence
below and replace the telephone number mentioned in the manual with the telephone number
that you wish to divert all calls to.
1234
+
3
+
+
1
+ +
161
+
96721777
+
2
+
How To Disable The Telco Arming Sequence
If at any time you wish to cancel the telco arming sequence, you may enter your
followed by
3
and the button, followed by
1
and the button,
then the button followed by the
4
and the button.
+
3
+ +
1
+
+ +
4
+
Electronics Design and Manufacturing Pty Limited ISSUE130