EDM Solution 862, Installation Manual

Page: 204 / 262

204
Solution 862
Installation Manual
System Event Timers
This section covers the features that involve timing. Features such as entry and exit times,
sensor watch time, siren run time and system date and time along with a host of other timers
are discussed extensively in this section.
Programming Entry/Exit Timers
There are two locations to be programmed for Entry Timer 1, Entry Timer 2, Exit Time For
AWAY Mode and Entry Guard Time For STAY Mode.
The first location of the timer is for programming increments of 1 second. The second location
of the timer is for programming increments of 16 seconds. By adding these two locations
together will give the total time required.
Example
If you require the entry time to expire after 18 seconds, you would need to program
“LOCATION 398” as 2 (i.e. 2 x 1 second = 2 seconds) and “LOCATION 399” as 1 (i.e. 1 x 16
seconds = 16 seconds). This would give you the total time of 18 seconds (i.e. 2 + 16 seconds =
18 seconds.
Entry Timer 1
LOCATION 398 - 399
(Defaulted To 20 Seconds
)
41
Location Description
398 Increments Of 1 Second (0 – 15 Sec’s)
399 Increments Of 16 Seconds (0 – 240 Sec’s)
Table 106: Entry Timer 1 Locations
Entry time can be programmed between 0 and 255 seconds in increments of one second. Entry
Timer 1 is the delay time used by the zone type – Delay-1. Refer to Zone Types on page 162
for more information.
Entry Timer 2
LOCATION 400 - 401
(Defaulted To 40 Seconds)
82
Location Description
400 Increments Of 1 Second (0 - 15 Sec’s)
401 Increments Of 16 Seconds (0 –240 Sec’s)
Table 107: Entry Timer 2 Locations
Entry time can be programmed between 0 and 255 seconds in increments of one second. Entry
Timer 2 is the delay time used by the zone type – Delay-2. Refer to Zone Types on page 162
for more information.
ISSUE130 Electronics Design and Manufacturing Pty Limited