EDM Solution 862, Installation Manual

Page: 38 / 262

Command 966 - Enable/Disable Automatic Stepping Of Locations
This command allows automatic stepping of locations while programming via Installer’s
Programming Mode. When enabled via the hand held programmer, the decimal point of the
left most display will reflect the mode of operation.
If the decimal point is illuminated on the hand held programmer, automatic stepping of
locations is active. n automatic increment of the location being programmed will occur as
soon as the
*
button is pressed positioning you at the next location ready for programming.
If the decimal point is not illuminated on the hand held programmer, the automatic stepping of
locations is disabled and programming the next location will need to be manually selected by
pressing the
#
button. As you can see from the examples below, auto step mode can be very
useful when programming successive locations.
When programming via the remote codepad, there are no visual indications to display if
automatic stepping of locations has been enabled.
How To Enable Automatic Stepping Of Locations
1. Enter Installer’s Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard.
If you are using the remote codepad, the
STAY
and
AWAY
indicators will begin to flash
to indicate that you have entered Installer’s Programming Mode. You will also notice
that the remote codepad will display the data currently programmed in “LOCATION
000”.
2. Enter command
966
followed by the
#
button.
Two beeps will be heard.
How To Disable Automatic Stepping Of Locations
1. Enter command
966
followed by the
#
button.
Two beeps will be heard.
Example
(Auto Step Enabled)
To enter the Primary Telephone Number "02 pause 9672 1055" with auto step enabled (i.e.
Decimal point illuminated when using the hand held programmer).
Press
0
followed by the
#
button.
(This will position you at "LOCATION 000" being the start of the Primary Telephone Number
For Receiver 1).
+
*
+
2
+
*
+ +
*
+
9
+
*
+
6
+
*
+
7
+
*
+
2
+
*
+
1
+
*
+ +
*
+
5
+
*
+
5
+
*
+
0
+
*
38
Solution 862
Installation Manual
ISSUE130 Electronics Design and Manufacturing Pty Limited
A