EDM Solution 862, Installation Manual

Page: 232 / 262

232
Solution 862
Installation Manual
Term Description
Is the amount of time you have to leave your premises after you have armed your system.
Exit Time or
Exit Delay
External Equipment
Is any device connected to your system such as detectors, codepads and sirens.
Forced Arming
Is a situation where your alarm system is permitted to be armed when one or more zones are
unsealed.
Handover Delay
When your system is armed and zone one is violated, the entry delay starts timing. If zone two is
then violated the entry delay time is handed over to zone two and so on through zones three and
four. This is known as sequential hand over delay.
Hand Held Radio
Hand held radio transmitters can be used to arm and disarm your system or cause a panic alarm.
Remote Control
Lockout Dialler
Lockout dialler means that the dialler will only activate once per zone per arming cycle.
Lockout Siren
Lockout siren means that the sirens will only activate once per zone per arming cycle.
Master Code
Is a numerical code used for arming and disarming the system as well as allowing access to all
functions that are programmable through the codepad.
Monitoring Station
Is a secure location where a digital receiver monitors numerous alarm systems and deciphers their
alarm transmission reports so that the operator can advise the appropriate authorities to take
immediate action.
Panic
This is a type of alarm raised by you to indicate to the monitoring station that there is an
emergency situation at your premises.
Phone Controller
Is a device used for arming your system via the telephone line. It is also used to acknowledge
domestic alarm reports.
Radio Remote User Codes
A radio user code that is used to arm and disarm the system remotely via hand held transmitters in
AWAY Mode or STAY Mode 1. Remote panic alarms are also allowed.
Sealed
Refers to a zones status. If a zone is sealed, the detection devices are not violated and the zone
indicator will be extinguished (i.e. a reed switch is closed or a detector is on stand by waiting for
an intrusion).
Sensor Watch
Sensor watch gives the control panel the ability to recognise that detection devices may have
stopped working. This is a feature that monitors the operation of a zone over a programmed time
period.
Silent Alarm
When programming your system, it is possible to have an individual zone for silent alarm. This
means that when the zone is violated your alarm system will communicate with the monitoring
station without sounding the sirens. This can only be programmed by your installer.
ISSUE130 Electronics Design and Manufacturing Pty Limited