EDM Solution 862, Installation Manual

Page: 244 / 262

244
Solution 862
Installation Manual
New Zealand Telepermit Notes
•
The grant of a telepermit for a device in no way indicates Telecom acceptance of
responsibility for the correct operation of that device under all operating conditions.
•
This equipment shall not be used in any manner that could constitute a nuisance to other
Telecom customers.
•
Immediately disconnect this equipment should it become physically damaged and
arrange for its disposal or repair.
•
The transmit level from this device is set at a fixed level and because of this there may
be circumstances where the performance is less than optimal. Before reporting such
occurrences as faults, please check the line with a standard telepermitted telephone and
do not report a fault if the telephone performance is satisfactory.
•
This device is equipped with pulse dialling while the Telecom standard is DTMF tone
dialling. There is no guarantee that Telecom lines will always continue to support pulse
dialling.
Use of dialling, when this equipment is connected to the same line as other equipment,
may give rise to bell tinkle or noise and may also cause a false answer condition.
Should such problems occur, the user should NOT contact the Telecom Faults Service.
•
This equipment is set up to carry out test calls at pre-determined times. Such test calls
will interrupt any other calls that may be set up on the line at the same time. The timing
set for such test calls should be discussed with the installer.
The timing set for test calls from this equipment may be subject to drift. If this proves
to be inconvenient and your calls are interrupted, then the problem of timing should be
discussed with the equipment installer. The matter should NOT be reported as a fault to
Telecom Faults Service.
•
This equipment shall not be set up to make automatic calls to the Telecom 111
Emergency Service.
This equipment should not be used under any circumstances that may constitute a
nuisance to other Telecom customers.
•
In the event of any problem with this device, the systems battery, AC mains supply and
telephone line should be disconnected. The user is to then arrange with the supplier of
the device to make the necessary repairs.
Should the matter be reported to Telecom as a wiring fault and the fault be proven to be
due to this product, a call-out charge will be incurred.
ISSUE130 Electronics Design and Manufacturing Pty Limited