EDM Solution 862, Installation Manual

Page: 34 / 262

34
Solution 862
Installation Manual
Command 962 - Copy Control Panel Memory To Programming Key
This command is used to copy the control panel memory to the programming key. Only the
Programming Key (CC891) may be used with the
Solution 862
control panel.
How To Copy The Control Panel Memory To The Programming Key
1. Enter Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash on the
remote codepad to indicate that you have entered Installer’s Programming Mode. You
will also notice that the remote codepad will display the data currently programmed in
“LOCATION 000”.
2. Plug the programming key onto the pins marked PROGRAMMING KEY on the control
panel found at the top of the PCB (printed circuit board) next to the Auxiliary Module
socket.
3. Enter command
962
followed by the
#
button.
Two beeps will be heard after the control panel memory has successfully been copied
into the programming key. If you heard a long beep after issuing this command, the
programming key has become corrupt and will need to be erased to clear the corrupt
data. Refer to Command 964 - Erase Programming Key on page 36 for more
information.
4. Before removing the programming key from the control panel, enter command
960
followed by the
#
button to exit Installer's Programming Mode. The STAY
and AWAY indicators will now extinguish on the remote codepad to indicate that the
system has returned to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the programming key.
How To Copy The Panel Memory To Programming Key Using The Hand Held Programmer
1. Before connecting the hand held programmer onto the pins marked PROGRAMMING
KEY, make sure that the switch on the hand held programmer is in the EXT position
and that no external key has been plugged onto the hand held programmer.
2. Enter Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the hand held programmer will display the data currently
programmed in “LOCATION 000”.
3. Plug the programming key onto the pins marked EXTERNAL KEY on the hand held
programmer.
4. Enter command
962
followed by the
#
button.
Two beeps will be heard after the control panel memory has successfully been copied
into the programming key. If you heard a long beep after issuing this command, the
programming key has become corrupt and will need to be erased to clear the corrupt
data. Refer to Command 964 - Erase Programming Key on page 36 for more
information.
5.
Before removing the programming key from the hand held programmer, enter command
960
followed by the
#
button to exit Installer's Programming Mode. Two beeps
will be heard and the system will now return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the programming key.
ISSUE130 Electronics Design and Manufacturing Pty Limited