EDM Solution 862, Installation Manual

Page: 108 / 262

108
Solution 862
Installation Manual
2
3
4
Bell Test
Holding the
2
button down until two beeps are heard will sound the internal screamers for a
two-second burst. No other sounding device will sound in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will test both the
horn speaker and the strobe connected to the satellite siren for a two second burst.
Strobe Test
Holding the
3
button down will operate the strobe. No other device will operate in this mode.
If an EDMSAT (SS914) has been connected to the control panel, this function will also test the
strobe on the satellite siren.
How To Turn Strobe Test ON
1. Hold down the
3
button until three beeps are heard.
The strobe will begin to flash.
How To Turn Strobe Test OFF
1. Hold down the
3
button until two beeps are heard.
The strobe will stop flashing.
Turning Day Alarm On and Off
Holding the
4
button down will turn day alarm on or off. If the STAY indicator is required to
indicate the status of day alarm operation (enabled/disabled), refer to Option 8 in "LOCATION
428" on page 219 for further information. The
STAY
indicator when enabled, will flash once
every 3 seconds to display when day alarm is active.
How To Turn Day Alarm ON
1. Hold down the
4
button until three beeps are heard.
Day alarm has now been turned on.
How To Turn Day Alarm OFF
1. Hold down the
4
button until two beeps are heard.
Day alarm has now been turned off.
ISSUE130 Electronics Design and Manufacturing Pty Limited