DURKOPP ADLER 577 Series, Manual

Page: 123 / 202

Key
Key 4
Key A
Key B
( Key B )
Function
Only when the Programming mode and "F - 020" are set
to "on" connect/disconect the knife
(without function)
Direct function:
Only when the parameter adjustment "F - 195" corresponds
to "4"
Short operation:
Reset the hook thread counter (after bobbin change)
Operation time longer than 1 second:
Connect/disconnect the hook thread counter
Programming mode:
Shift key
(see the Operating Instructions of the motor manufacturer)
Adjustments
on / oFF
5.3 Changing parameter values
NOTE !
It is absolutely necessary to complete a sewing cycle after the
parameter change. It is only then that the modified adjustment will be
definitely memorised. If no sewing is done, the new setting will be lost
by turning off the main switch!
For changing or switching on and off the parameters press the keys
"P" , "E" , "+" and "-" on the control panel.
The parameters that can be changed on the operator level are stated
in the following parameter list.
Calling up programming mode
–
Operate the key "P" .
The parameter, called up as last one, will appear.. If no parameter
has yet been called up after turning on the main switch, the display
will present
"F - 000" .
Selecting the desired parameter
–
Operate the key "+" or the key "-" .until the desired parameter is
displayed
–
The parameter value will be displayed after pressing the key "E" .
Changing the displayed parameter
–
For changing the parameter value or for switching on or off the
parameter function press the keys
"+" or "-" .
Memorising the modified parameter value
–
Press the key "E" for changing further parameter values.
The modified parameter value will be memorised. The display will
present the next parameter on the operator level.
or:
–
Press the key "P" in order to quit the programming mode.
The parameter value, modified as last one, will be memorised.
The control system will quit the programming mode.
1
21