DURKOPP ADLER 577 Series, Manual

Page: 197 / 202

11.4 State display
Display Denomination
InF A1
InF A3
InF A4
InF E1
InF E2
InF E3
InF E4
InF H1
InF H2
InF P1
InF P2
Pedal not in zero position when switching On
The position, being of reference for all other position
values, has not been memorised (no reference position).
The control part cannot be clearly recognised.
Position transmitter not connected or defective.
Mains voltage too low
Mains voltage too low, or mains Off >On too short
Machine jams or does not attain the desired speed.
Control unit disturbed by non-existent earth contact or by a
tottering contact.
Commutation transmitter line or the frequency converter
disturbed
Processor disturbed
Error in the determination of the after-run stitches.
Number of the after-run stitches too low
Error in the determination of the after-run stitches.
Number of the after-run stitches too high
Machine runs
The hook thread monitor can be engaged.
( only if the parameter
"F - 195" is set on "4" )
blinking symbol:
The counting for the hook thread monitor has started.
Blinking symbol and display of "C D":
End of counting, change the bobbin!
3
47