DURKOPP ADLER 577 Series, Manual

Page: 194 / 202

ATTENTION !
Following a parameter change it is absolutely necessary to proceed to
a sewing test . It is only then that the modified settings will be
memorised definitely. If no sewing is done, the new settings will be los
as soon as the main switche is turned off!
For changing, switching on or off the parameters use the keys "P" ,
"E" , "+" as well as "-" on the control panel .
The parameters that can be changed on the operator level are shown
in the following parameter list.
Calling up programming mode
–
Press the key "P" .
The parameter called up as last one will appear. If no parameter
has been called up after turning on the main switch, the display will
show
"F - 000" .
Selecting the desired parameter
–
Repeat pressing the key "+" or "-" until the desired parameter is
displayed.
–
Press the key "E" for displaying the parameter value.
Changing the displayed parameter
–
Press the keys "+" or "-" for changing the parameter value of for
switching on/off the function.
Memorising the changed parameter value
–
Press key "E" for changing further parameter values.
The modified parameter value will be memorised. The display will
show the next parameter of the operator level.
or:
–
Press the key "P" , for quitting the programming mode.
The parameter value modified as last one will be memorised.
The control will leave the programming mode.
44