DURKOPP ADLER 577 Series, Manual

Page: 125 / 202

State Display
Display Denomination
InF P1 Error in the determination of the after-running stitches.
The number of the after-running stitches is too low.
InF P2 Error in the determination of the after-running stitches.
The number of the after-running stitches is too high.
The machine runs
The hook thread monitor can be switched on.
(only when the parameter
"F - 195" is set to "4" )
blinking symbol:
The counting for the hook thread monitor has commenced.
Blinking symbol and display of "C D":
The counting has ended, change the bobbin!
The display of the control panel will present up to 4 different
inadmissible conditions resulting from a number combination.
Sewing cage not in its initial position (rear pos)
Thread take-up lever not in its top dead centre
position. (needle not in upper pos.)
Needle thread monitor acting
Instant stop has been released (stop)
A combination of several inadmissible conditions is possible, e.g.:
A
_ 0 1 0 1
Needle thread monitor active / Sewing cage not in rear
position
Display of the sewn buttonholes.:
B max. 65535
1 2 3 4 5
The counting for the hook thread monitor has ended.:
C D
1 2 3 4 5
A
_1 1 1 1
1
23