Dodge Challenger 2018, Owner'S Manual

Page: 339 / 512

To do this, you will need follow the procedure below:
1. Remove the four nuts with the Shaker tool located in
glove compartment.
2. Lift off the upper scoop.
NOTE:
Be sure to clean off all debris around or inside for
the shaker assembly.
3. Locate the oil fill cover in base assembly to expose the
oil fill cap.
4. Remove oil fill cap to add oil.
5. Re-install shaker assembly.
Shaker Hood Air Filter Cleaning
1. Remove the air filter from the intake and set the filter
clamp a side.
2. Measure the length of the filter media.
3. Fill a bucket with warm clean water to the depth
matching the filter media measurement and add a mild
household detergent or air filter cleaning solution.
4. Without allowing the solution to flow back into the
inside of the air filter, submerge the filter media in to the
water and let it soak for ten minutes.
5. Empty the bucket filled with dirty water and repeat
steps 3 and 4.
6. Refill the bucket with clean warm water and rinse the
filter by rotating the filter.
NOTE: The water should be clean with no signs of dirt in
the bucket.
7. Allow the filter to air dry. Re-install the filter on the
intake system once it is dry.
Shaker Hood Removal And Cleaning
1. Remove the four nuts with the Shaker tool located in
glove compartment.
2. Lift off the upper scoop.
NOTE:
Be sure to clean off all debris around or inside for
the shaker assembly.
3. Using a water and mild detergent clean the following
locations.
— The water drain slot located at the front forward edge of
the shaker assembly.
— The seals attached to the scoop and air box.
8
SERVICING AND MAINTENANCE 337