High Speed Interface Configuration Screen (DLE28-MA Only)
DLE28-MA User’s Guide
5-83
5.23.3
Configuring a DELTX-UI
In normal operation, a port (25 or 26) with a DELTX-UI interface
automatically establishes a link with the device at the other end of the
segment and no user setup is required. Section 5.23.4 and Section 5.23.5
provide instructions for manually configuring the port with a DELTX-UI
installed.
5.23.4
Setting the DELTX-UI Operational Mode
Use the Desired Oper. Mode field to set the active technology. This field
steps between Auto-Negotiation, 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). If Auto-Negotiation is
selected, the DELTX-UI automatically sets the active technology. To
manually set the active technology through Local Management, proceed
as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
2.
Use the SPACE bar to select the desired mode. Press ENTER. If any
mode other than Auto-Negotiation is selected, the port only operates
in the chosen mode and auto-negotiation is disabled.
3.
Use the arrow keys to highlight the SAVE command. Press ENTER.
The message “SAVED OK” displays and Local Management saves
the changes to memory. The selected mode is displayed in both the
Desired Operational Mode field and the Current Operational Mode
field.
5.23.5
Setting the DELTX-UI Advertised Ability
In normal operation, a port (25 or 26) with a DELTX-UI auto-negotiates
to the highest speed possible. Under some circumstances, the Network
Administrator may want the port to advertise only some of the available
modes and not operate in other modes. This field steps between 10Base-T,
10Base-TFD (full duplex), 100Base-TX, and 100Base-TXFD (full
duplex). To set the advertised ability, proceed as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
2.
Use the SPACE bar to select the desired mode.
3.
Use the LEFT-ARROW key to move back to the Advertised Ability
selection and use the SPACE bar to select the next mode to enable or
disable.
