Chapter 5: Local Management
5-50
DLE28-MA User’s Guide
5.15.9
Setting the Operational Mode
To set the Operational Mode, proceed as follows:
1.
Use arrow keys to highlight the Operational Mode field.
2.
Press the SPACE bar to step to the appropriate operation mode,
(802.1D SWITCHING, 802.1Q SWITCHING).
3.
Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown back in Figure 5-18 displays.
4.
Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
5.15.10 Setting the Management Mode
To set the management mode, perform the following steps:
1.
Use the arrow keys to highlight the Management Mode field:
2.
Use the SPACE bar to toggle the options (DISTRIBUTED or
STAND ALONE) until the desired mode displays.
3.
Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown back in Figure 5-18 displays.
Upon saving the new operational mode, the module will reboot.
If the DLE28-MA have been set to 802.1Q SWITCHING, refer
to your
Port Based VLAN User’s Guide to configure the devices
for this type of operation.
Upon saving the new Management Mode, the module will
reboot.
If the module will be set to STAND ALONE, ensure the
following procedures have been completed:
The module has been assigned a unique IP address.
The module has been assigned SNMP community names from
the module SNMP Community Names screen (Section 5.16).
In STAND ALONE management mode, the module does not
use the community names of the DLM6C-AA chassis.
