Chapter 5: Local Management
5-64
DLE28-MA User’s Guide
5.18.2
Setting the Age Time
To set the Age Time, proceed as follows:
1.
Use the arrow keys to highlight the Age Time field.
2.
Enter the desired Age Time in increments of 10. The available Age
Time range is 10 seconds to 1,000,000 seconds with the default value
being 300 seconds.
3.
Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4.
Press ENTER. The message “SAVED OK” displays.
5.18.3
Setting (Enabling or Disabling) the Port Status
To set the status of an interface (port), proceed as follows:
1.
Use the arrow keys to highlight the Status field of the port.
2.
Use the SPACE bar to toggle to either ENABLED or DISABLED.
3.
Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4.
Press ENTER. The message “SAVED OK” displays.
5.19
ETHERNET FULL DUPLEX CONFIGURATION
SCREEN
The Ethernet Full Duplex Configuration screen, Figure 5-24, allows the
user to set ports 1 through 24, individually or all at once, to either
Standard Ethernet or Full Duplex operation and monitor each port to see
whether or not it is enabled and linked to another device.
To access the Ethernet Full Duplex Configuration screen from the Module
Specific Configuration Menu screen, use the arrow keys to highlight the
ETHERNET FULL DUPLEX CONFIGURATION menu item in the
Disabling the port status of a backplane connection will block
the module from passing user traffic to the applicable module
slot in the DLM6C-AA chassis. SNMP and other management
traffic (e.g., ping and Telnet traffic), however, will still pass via
the backplane to the applicable module slot.
