DATREND Systems ES601 Plus, Operating Manual

Page: 172 / 233

ES601 Plus OPERATING MANUAL
8.5.26 Printing AutoSequences
Press the Print button to show the print dialogue. Select the current sequence radio button and press
OK to print out the current AutoSequence. Select the All Sequences radio button and press OK to
print out all 24 AutoSequences. Pressing Cancel will close the print dialogue without printing.
Return to Main Menu
When edits have been completed, the user may return to the main menu of the ES601pc application
by pressing this button. Remember, at this point, all changes that have been made have already been
saved.
If the configuration that existed when entering the Editor may be required at
a later time, be sure to
Backup the configuration before making any edits.
8.6 ECG AutoSequence Editor (standard accessory)
In addition to an electrical safety analyzer, ES601
Plus
incorporates an electrocardiogram (ECG)
simulator. The ECG Simulator of ES601
Plus
generates 40 different test signals the user can activate
manually using a menu system. In addition to the waveform, the amplitude of the output signal can
be set to one of three values: 1 mV (standard), 2 mV, or 0.5 mV (in Lead II).
As an alternative to manually operating the simulator, the user can run an ECG AutoSequence in
which ES601
Plus
can be stepped through a predetermined list of up to 24 selected waveforms of
given amplitudes. At each step of the ECG AutoSequence, the user can enter either a "PASS" or
"FAIL”. At the end of the ECG AutoSequence, the user can optionally enter a comment of up to 40
characters (e.g. "LEAD III NOT WORKING").
ES601
Plus
provides 6 programmable ECG AutoSequences, each having from one to 24
waveform/amplitude steps. ES601pc is used to select the waveforms and amplitudes for each step
of each ECG AutoSequence and program this setup into ES601
Plus
.
Upon selecting ECG AUTOSEQUENCE EDITOR, you are taken to the editor screen (shown in
Fig u re 89 ).
ES601pc Software/Chapter 8
#
Page 153