3
FEATURE DEFINITIONS
Partitions
-
The DL-300E can be partitioned into a maximum of four separate systems with distinct reporting codes and user
codes per system. See page 23 for instructions.
Secondary Exit Delay
- Used most often for garage doors, this zone type is a second entry/exit delay that has its own
delay times, independent of the standard entry/exit delay zone.
Group Isolate
-
Zones can be programmed to isolate as a group when the [*] digit is pressed during the exit delay. This
feature is enabled in Locations 155-170:
Assigning Special Characteristics
For
Zones
beginning on page 14 of this manual.
Partial Mode
-
This unique low level arming allows you to remain inside your home and only arm areas that are not occupied.
For example, Night Arming.
Chime
-
This lowest level of security can be enabled by zone (see page 15, Locations 171-186:
Assigning Audible
Characteristics
For
Zones)
to create a one second tone through the code pad sounder when the system is disarmed and a zone is
violated. If so programmed, this feature can be turned on and off by a one digit keypress programmed in Location 244:
Assigning
The Chime Code
on page 23 of this manual.
Auto Isolate Enable
-
When enabled in locations 205, the DL-300E can be armed with zones violated, lacking a green
"Secure" light on the code pad. Under this condition, all zones that are not secure at the end of the exit delay will become isolated
All zones that become secured before the end of the exit delay will become active in the system.
Dialer Acknowledge Feature-
When enabled in location 212, a two second audible output of the siren or bell will
occur after a kissoff has been received by the control panel. I E. (When the system is fully armed and finished communication to the
base station.)
Dynamic Battery Test
-
When enabled in locations 254-255, the DL-300E can be programmed to perform a dynamic
battery test for a selected duration, at a selected time.
Internal Event Log -
Up to 256 events can be stored in memory along with the date and time of the event. These
events can later be viewed through downloading, and/or sent to an on-site printer which can be connected to the DL-300E through
one of the available expansion devices.
Site Initiated Downloading
- The control panel can be programmed to automatically call the download software at a
specific time (also see location 622 on page 31).