10
NON-PARTITIONED
SYSTEMS
When partitioning is not being utilized, locations 064-079 can be used to control the arming and disarming authority of the
individual arm/disarm codes. A code can be given limited authority by programming a number from 1 to 15 in the corresponding
location for that code. Add the values in the table below that correspond to the desired arm/disarm characteristics, and program
the sum in the appropriate locations.
-
VALUE
AUTHORISATION LEVEL
VALUE
AUTHORISATION LEVEL
0
NO AUTHORISATION LEVEL
(USED
FOR AUXILIARY OUTPUT)
9
REGULAR ARM/DISARM CODE
OPEN/CLOSE REPORTS BY USER
1
REGULAR ARM/DISARM CODE
10
ARM ONLY AFTER CLOSING TIME
OPEN/CLOSE REPORTS BY USER
2
ARM ONLY AFTER CLOSING TIME
NORMALLY REGULAR CODE,
CHANGE TO ARM ONLY CODE
AFTER THE CLOSING TIME, RESET AT
THE OPEN TIME
12
ARM ONLY CODE
OPEN/CLOSE REPORTS BY USER
4
ARM ONLY CODE
Location 080-095: Programming Phone #1
Phone #1 is programmed in successive locations beginning with location 080. Delays of four seconds can be programmed at any point in
the phone number by programming a "13" in the appropriate location. If tone dialing is desired, program a "15" in the location where tone
dialing should begin. If the entire number should be tone dialing, program a "15" in location 080. Factory default is "14" in each location
and the phone number is not enabled. When using split or dual reporting, phone #1 always take priority over phone #2. A "14" indicates
the end of the phone number. EXAMPLE: Phone number 02-7244211 with touch tone dialing would be entered as [1][5][*][#] [0][*][#]
[2)[*][#] [7][*][#] [2][*][#] (4][*][#] [4][*][#J [2][*][#] [1][*][#] [1][*][#] [14][*][#]. The "15" selects touch tone dialing, and the
"14" end the phone number.
Location 096-100: Programming The Account Code For Phone #1 (Or Partition One)
The account code sent when phone #1 is dialed is programmed in locations 096-100.. If the account code is three digits long, use
locations 096 097, 098, and program a "0" in locations 099 and 100. If the account code is four digits long, program a "0" in location
100. If a zero "0" is part of an account code, it should be programmed as a "10". Program a "0" to indicate the end of the account code.
To make this account code the account code for "Partition One", see location 132. EXAMPLE: Account number of 2090 would be entered
as [2][*][#j [10][*][#] [9][*][#] [10][*][#] [0][*][#] (starting at location 96). Account code of 209 for low speed
Location 101: Communicator Format For Phone #1
Location 101 contains the communicator format used to transmit to the receiver connected to the phone #1. Consult the instructions for
your central station receiver to determine which format is compatible. Select a format from the 14 listed on page 10. If you require a
format other than those listed, review the override options described in locations 610-615, to build the appropriate format. A "15" must
be programmed in location 101 in addition to the entries into locations 610-615 in order to create a special format. If this location
contains a "0", the built-in communicator will be disabled, and the DL-300E will function as a local only control.