130B
T117.10
OK
Back
In
fo
Warm
Alarm
On
Canc
el
Operation keys
for local control are found at the bottom of the control
panel.
130BP046.10
Hand
on
Off
Auto
on
Reset
[Hand on]
enables control of the adjustable frequency drive via the
GLCP. [Hand on] also starts the motor, and makes it
possible to give the motor speed reference using the
arrow keys. The key can be
Enabled
[1] or
Disabled
[0] via
par.
0-40 [Hand on] Key on LCP.
The following control signals will still be active when
[Hand on] is activated:
•
[Hand on] - [Off] - [Auto on]
•
Reset
•
Coasting stop inverse (motor coasting to stop)
•
Reversing
•
Set-up select lsb - Set-up select msb
•
Stop command from serial communication
•
Quick stop
•
DC brake
External stop signals activated by means of control signals
or a serial bus will override a “start” command via the LCP.
[Off]
stops the connected motor. The key can be
Enabled
[1] or
Disabled
[0] via par.
0-41 [Off] key on LCP.
If no external
stop function is selected and the [Off] key is inactive, the
motor can only be stopped by disconnecting the line
power supply.
[Auto on]
enables the adjustable frequency drive to be controlled via
the control terminals and/or serial communication. When a
start signal is applied on the control terminals and/or the
bus, the adjustable frequency drive will start. The key can
be
Enabled
[1] or
Disabled
[0] via par.
0-42 [Auto on] key on
LCP.
An active HAND-OFF-AUTO signal via the digital inputs has
higher priority than the control keys [Hand on] – [Auto on].
[Reset]
is used for resetting the adjustable frequency drive after an
alarm (trip). The key can be
Enabled
[1] or
Disabled
[0] via
par. 0-43
Reset Keys on LCP
.
The parameter shortcut
can be carried out by holding down the [Main Menu] key
for 3 seconds. The parameter shortcut allows direct access
to any parameter.
5.1.3 Changing Data
1.
Press the [Quick Menu] or [Main Menu] key.
2.
Use [
▲
] and [
▼
] keys to find parameter group to
edit.
3.
Press [OK] key.
4.
Use [
▲
] and [
▼
] keys to find parameter to edit.
5.
Press [OK] key.
6.
Use [
▲
] and [
▼
] keys to select correct parameter
setting. Or, to move to digits within a number,
use the left or right arrow keys. Cursor indicates
digit selected to change. [
▲
] key increases the
value, [
▼
] key decreases the value.
7.
Press the [Cancel] key to disregard the change, or
press the [OK] key to accept the change and
enter the new setting.
5.1.4 Changing a Text Value
If the selected parameter is a text value, it can be changed
by using the up/down navigation keys.
The up key increases the value, and the down key
decreases the value. Place the cursor on the value to be
saved and press [OK].
130BP068.10
740RPM
0 -01 Language
[0] English
10.64 A
1 [1]
0-0*
Basic Settings
Figure 5.1 Display example.
How to operate the adjustab...
VLT AQUA 12-Pulse High Power Instruction Manual
5-4
MG.20.Y1.22 - VLT
®
is a registered Danfoss trademark
5
5
