SUMMARY STEPS
1.
Before servicing the power supply, switch the circuit breaker Off in your equipment area. As an additional
precaution, tape the circuit breaker switch in the Off position.
2.
Slip on the ESD-preventive wrist strap that was included in the accessory kit.
3.
Switch the power supply circuit breaker switch to Off (O).
4.
Locate the terminal block on the rear of the chassis on the power supply.
5.
Remove the slotted plastic cover from the terminal block (see xref figure).
6.
Locate the power supply ground stud (see xref fig). Remove the ground (GND) cable from the DC power
supply.
7.
Loosen and remove the Kepnut screw, washer, and ground lug in that order.
8.
Loosen the four captive screws on the DC power supply.
9.
Grasping the power supply handles, pull the power supply from the chassis.
10.
Replace the DC power supply within five minutes.
DETAILED STEPS
Step 1
Before servicing the power supply, switch the circuit breaker Off in your equipment area. As an additional precaution,
tape the circuit breaker switch in the Off position.
Step 2
Slip on the ESD-preventive wrist strap that was included in the accessory kit.
Step 3
Switch the power supply circuit breaker switch to Off (O).
Step 4
Locate the terminal block on the rear of the chassis on the power supply.
Cisco ASR 1000 Series Router Hardware Installation Guide
546
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router
Summary of Contents for ASR 1001
Page 2: ... 2013 2017 Cisco Systems Inc All rights reserved ...
Page 20: ...Cisco ASR 1000 Series Router Hardware Installation Guide xx Contents ...
Page 30: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxx Preface Warning Definition ...
Page 32: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxxii Preface Warning Definition ...
