Cisco ASR 1001, Hardware Installation Manual

Page: 76 / 702

Table 11: Cisco ASR 1000 Series Route Processor Connectors
Description Type Label
A recessed button to cut off the
audible alarm. This is triggered
when the critical, major, or minor
LED is set. Audible Cutoff button ACO
Side-by-side USB connector used
with memory sticks or smart cards
for secure key distribution USB0 interface 0
Side-by-side USB connector used
with memory sticks or smart cards
for secure key distribution USB1 interface 1
Indicates BITS timing reference. RJ-45 connector BITS
The route processor has an ENET
port with a RJ-45 connector to
attach a management device or
network for network management. One RJ-45 jack for copper Ethernet
Management Port MGMT ETHERNET
Console port used to connect to a
terminal. One RJ-45 for CON/AUX CON
Auxiliary port used for remote
management purposes. One RJ-45 for CON/AUX AUX
Out of Band (OOB) or modem connection in the AUX and/or CON ports, regardless of being properly
configured, the connection is not established and a call cannot be setup. This functionality is not supported
on any of the Cisco ASR 1000 Series Aggregation Services Routers or on any of the Cisco IOS XE
versions.
Note
The Cisco ASR 1000 Series Route Processor meets the following requirements:
• Supports up to 4 GB of memory with single-bit error correction and multi-bit error detection (except
for the Cisco ASR 1002 embedded route processor)
• Supports On-board Failure Logging (OBFL) with 2MB of memory
• Supports the Cisco ASR 1000 Series Router system architecture and midplane
• Enhanced Serdes Interconnect (ESI) at 11.5 Gbps.
• Gigibit Ethernet switches for EOBC communication and boot-up of the Cisco ASR 1000 Series SPA
Interface (SIP) and Cisco ASR 1000 Series Embedded Services Processor.
• Runs Cisco IOS network control plane (routing protocol, connections setup)
Cisco ASR 1000 Series Router Hardware Installation Guide
42
Cisco ASR 1000 Series Routers Component Overview
Cisco ASR 1000 Series Route Processor Differences