What to Do Next
This completes the steps for removing the Cisco ASR1002-X DIMMs from the module.
Replacing the Cisco ASR1002-X Router DIMMs
This section lists the steps to replace the Cisco ASR1002-X Router DIMMs.
SUMMARY STEPS
1.
Place the module on an antistatic mat or pad and ensure that you are wearing an antistatic device, such as
a wrist strap.
2.
Position the module so that the faceplate is toward you and the edge connector is away from you.
3.
Remove the new DIMM from the antistatic bag.
4.
Hold the DIMM component-side up, with the connector edge (the metal fingers) closest to you. Hold the
ends of the DIMM between your thumb and forefinger. See the following figure.
5.
Align the DIMM with the socket, and insert the connector edge into the socket. Note the two notches
(keys) on the connector edge of the DIMM. These keys are intended to ensure correct orientation of the
DIMM in the socket.
6.
Note the orientation of the socket key on the DIMM and the DIMM socket, and gently push the DIMM
into the socket until the lever is flush against the side of the DIMM socket, and the DIMM edge connector
is fully inserted. If necessary, rock the DIMM gently back and forth to seat it properly. The following
figure shows how to install the DIMM in the socket.
7.
When the DIMM is installed, check that the release lever is flush against the side of the DIMM socket. If
it is not, the DIMM might not be seated properly. If the DIMM appears misaligned, carefully remove it
according to the removal procedure and then reseat it in the socket. Push the DIMM firmly back into the
socket until the release lever is flush against the side of the DIMM socket.
8.
Repeat Step 3 through Step 7 for the remaining DIMMs.
9.
Replace the module.
DETAILED STEPS
Step 1
Place the module on an antistatic mat or pad and ensure that you are wearing an antistatic device, such as a wrist strap.
Step 2
Position the module so that the faceplate is toward you and the edge connector is away from you.
DIMMs are sensitive components that can be shorted by mishandling; they are susceptible to ESD damage.
Handle DIMMs by the edges only and avoid touching the pins.
Caution
Cisco ASR 1000 Series Router Hardware Installation Guide
517
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1002-X Router DIMM Memory Modules
Summary of Contents for ASR 1001
Page 2: ... 2013 2017 Cisco Systems Inc All rights reserved ...
Page 20: ...Cisco ASR 1000 Series Router Hardware Installation Guide xx Contents ...
Page 30: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxx Preface Warning Definition ...
Page 32: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxxii Preface Warning Definition ...
