SUMMARY STEPS
1.
Connect a console terminal to the console port, and then boot the router.
2.
The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When asked
if you would like to enter the initial configuration dialog, enter yes.
DETAILED STEPS
Step 1
Connect a console terminal to the console port, and then boot the router.
This is only an example of the output display; prompts may
vary.
Note
When you see this information, you have successfully booted your router:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses of the setup
facility, the script begins with a System Configuration Dialog as shown below: When asked if you would like to enter
the initial configuration dialog, enter yes.
Example:
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended
setup will ask you to configure each interface on the system.
Basic management setup configures enough connectivity for managing the system; extended setup will ask you
to configure each interface on the system. For detailed information about setting global parameters, refer to the
Cisco ASR 1000_Series Aggregation Services Routers Software Configuration Guide.
Note
Cisco ASR 1000 Series Router Hardware Installation Guide
469
Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Configuring Global Parameters
Summary of Contents for ASR 1001
Page 2: ... 2013 2017 Cisco Systems Inc All rights reserved ...
Page 20: ...Cisco ASR 1000 Series Router Hardware Installation Guide xx Contents ...
Page 30: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxx Preface Warning Definition ...
Page 32: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxxii Preface Warning Definition ...
