Chevrolet 10 Series 1968, Service Manual

Page: 86 / 713

BODY IB-19
Fig.
48
- Handle and
Lock
(Outside
Door)
3. Pivot remote inboard slightly, to disengage connect­
ing rod, and remove remote from door.
4. To install, reverse removal procedure.
NOTE:
Connecting rod can be removed at this
point by disconnecting spring clip from lock.
REAR SIDE D O O R -P A N EL AND SUBURBAN LOCK
Removal and Installation (Fig. 51)
1. Wind window glass to closed position.
2. Remove control knobs and trim assembly.
3. Remove three (3) screws from the door end - at the
rotor lock.
4. Remove two (2) spring clips from the control rods.
(Refer to View "B ", fig. 51.)
5. Move the lock assembly inward, rotate around the
channel assembly and remove through the door ac­
cess hole.
6. Reverse procedure to install.
REMOTE CONTROLS (FRONT, CENTER AND REAR)
AND CONNECTING RODS
Removal and Installation
1. Follow above procedure for lock removal.
2. Remove three (3) screws from center remote control
mechanism and remove with attaching rod and spring
clip. (See Figure 52.)
NOTE:
Note position of rod end if disconnect­
ing for proper replacement.
3. Unscrew door lock control button from door assem­
bly.
4. Remove five (5) attaching screws and the upper trim
molding: two (2) forward, one (1) center and two (2)
rear screws. The forward and rear remote control
assemblies are attached by these same screws.
5. Lower the rear remote control assembly far enough
for removal of the spring clip attachment through a
door access hole. (See Figure 53.)
6. Remove rear remote control through large door ac­
cess hole.
F ig . 4 9 - Lock C y lin d e r Installed
7. Guide the attaching rod with the front remote control
assembly through the lock hole at the rear of door -
tilt upward to clear the regulator assembly and then
back out the access hole. (See Figure 54.)
8. Reverse procedure to install.
BODY SIDE WINDOW ASSEMBLY (ROADSIDE)
AND FRONT STATIONARY W IN D O W -
SUBURBAN (Figs. 55 & 56)
Stationary Glass Replacement
1. Wind window to full down position.
2. Remove hand controls and trim panel.
3. Remove cats whiskers and rubber stripping or seal.
4. Remove one upper door attaching screw and two
lower securing the window divider run.
CHEVROLET TRUCK SERVICE MANUAL