Chevrolet 10 Series 1968, Service Manual

Page: 580 / 713

CHASSIS SHEET METAL 11-9
F ig . 12—Fender S k irt, Dash and Toe Pan Assy. - P -2 0 -3 0
17. Tighten right fender skirt front 3 bolts from under­
side to radiator support.
18. Place battery tray in position and fasten to radiator
support.
19. From beneath skirt fasten screw to battery tray
bottom.
20. Install bolt and shim loosely bottom of front fender
rear to hinge pillar.
21. Tighten
6
grille fille r panel screws previously at­
tached to radiator support.
22. Install radiator, hoses and shroud.
23. Connect removed wiring to radiator support.
24. Install both head lamp assemblies.
25. Tighten all previously installed bolts, screws loosely
attached.
26. Install battery and connect leads and wires.
27. Fill radiator with coolant as specified in Section 13.
28. Install hood on previously marked outline.
29. Install and secure cowl grille.
30. Install windshield wiper arm assemblies.
FRONT FENDER
10 thru 30 Series
9. Remove bolt and shim attaching to trailing edge of
fender to hinge pillar.
10. Remove two bolts and shims at top rear of fender
attaching to cowl.
Installation
To install, reverse the removal procedure using seal­
ing tape between fille r panel and fender. Check sheet
metal alignment.
40 thru 60 Series
Rem oval
1. Remove windshield wiper arms.
Rem oval
1. Remove windshield wiper arms, cowl grille and at­
taching screws.
2. Remove hood and hinge assembly.
2a. Remove front bumper.
3 0 Remove head lamp door, wiring and attachments
from fender.
4. Remove screws attaching fender wheel opening flange
to skirt.
5. Remove 2 skirt to fender bolts, located inboard on
underside of skirt.
6 . Remove two screws attaching gusset to fender.
7. Remove two screws attaching radiator support to
front fender.
8
. Remove four bolts attaching radiator grille to fender.
F ig . 13—Fender Attachments 4 0 -6 0 Series
CHEVROLET TRUCK SERVICE MANUAL