Chevrolet 10 Series 1968, Service Manual, Page: 79 / 713

BODY IB-12
'jfPW
—1
RIGHT SIDE LOCK
ROD AND SPRING CLIP
GATE
LOCK
FORWARD
I
REMOTE
ASSEMBLY
LEFT SIDE LOCK
ROD AND SPRING
CLIP I
Jijjs: :t: •' M "
Adjustment
Elongated holes with two large screws and external
tooth washers are provided in the remote and push button
control assembly plate to provide for needed adjustment.
F ig .
30 -
Endgate Remote and Push Button Control Assembly
3. Remove two (2) screws securing the remote and push
button control assembly plate.
4. Pull out the remote and push button control assembly
to remove the left side lock rod spring clip. (See
Figure 31.)
5. Hold the center lock spring lever out of the way and
remove the control assembly.
6. Reverse the procedure to install.
Push Button Assembly
If necessary to remove the push button assembly, apply
the above Remote and Push Button Control steps and pro­
ceed as follows:
1. Secure the Remote and Push Button Control Assem­
bly and remove two screws from the back of the
plate.
2. Rotate the push button assembly to release the lock
assembly and remove.
3. Reverse procedure to install.
F ig . 31 - Endgate Remote and Push Button Control Replacement
Lock Cylinder Escutcheon
Rem oval and Installation
1. Apply above Remote and Push Button Assembly Re­
moval procedures.
2. Remove two nuts securing the escutcheon.
3. Remove escutcheon and gasket.
4. Reverse procedure to install„
Endgate Centerlock
1. Remove four (4) screws from endgate end.
2. Remove centerlock assembly.
3. Reverse above procedure to install.
Endgate Side Lock
1. Remove Remote and Push Button Assembly mechan­
ism access hole cover.
2. Remove right or left side lock rod spring clip.
3. Remove four (4) screws and lock washers.
4. Guide rod and side lock from endgate.
5. Reverse procedure to install.
F ig . 32 - Panel and Suburban Endgate, Liftgate and
Rear Door Strikers - Adjustment
CHEVROLET TRUCK SERVICE MANUAL