Chevrolet 10 Series 1968, Service Manual

Page: 70 / 713

BODY IB-3
F ig . 5 —Cab Se alin g Areas (T /p ica l)
1. Hinge P illa r to Cow l Side & 6. Floor & Fender Bracket
Cow l Top to Plenum - Cab to Front Cross S ill & Side
2. Dash Panel & Cow l Side Inner to P illa r F/F Cow l
Panel to Floor Panel - 7. Undercoating
C ab & W /S Cowl 8. C ab Door
3. Upper Cab & Drip 9. W /S P illa r to W indshield
M olding Cab Header
4. Hinge P illa r & Lock P illa r C ab 10. Cowl Side to Cow l Top
5. Roof O uter & Back Panel Cab Lap Jt.
CHEVROLET TRUCK SERVICE MANUAL
F ig . 3 - Body Mounting - Cab Rear
F ig . 4 - Panel and Suburban Body Mounts - ^2, 3 , 4 & 5
Remove the following trim from inside the cab: Floor
mats, dash and toe panel pad and kick pads.
Dust leaks will be evident when these pads and mats
are removed. Leaks can be located sometimes by putting
a bright light under the cab or body, while checking the
interior of the cab or body at joints and weld lines.
All openings that allow dust leaks will also provide
water leaks. When checking for water leaks a helper
should be used on the inside of the cab or body to locate
the entrance of water, while it is applied on the outside.
REAR PLATFORM
MOUNT
MEMBER
05-06-16 MODELS
BODY SIDE
NO. 4
BODY
FRAME
NO. 2
BODY MOUNT
FWD
M ODELS O N LY
J