Chevrolet 10 Series 1968, Service Manual, Page: 682 / 713

ACCESSORIES 15-8
B R O W N
BLUE
C R U IS E P O S IT IO N
B U TTO N R E LE A S E D
E N G A G E P O S IT IO N
B U TTO N P A R T IA LLY
D E P R E S S E D
TRIM P O S IT IO N
B U TTO N FU LLY
D E P R E S S E D
TO “ACC FUSED"
TERMINAL OF ^—
FUSE PANEL
ENGAGE SWITCH
I
r o w n
B L A C K
ENGAGE SWITCH
CONFIGURATION
WHITE
BROWN/WHITE STRIPE
BRAKE
SWITCH
RED
CLUTCH
SWITCH
RED
y
RED
B R O W N / W H IT E STRIPE
W H ITE
RESISTANCE
WIRE 4012
\
SOLENOID COIL
(512 RESISTANCE)
REGULATOR
CONNECTOR
BROWN/
WHITE
STRIPE
REGULATOR
F ig . 10—Cruise Master W iring Diagram
Adjustment
—The brake switch plunger must clear the
pedal arm when the arm is moved 5/16 inch measured at
the switch (Figure 7).
ENGAGEMENT SWITCH
Service
— The engagement is serviced o n l y by
replacement.
Removal
1. Disconnect battery ground cable.
2. Pry the engagement button out of the turn signal
knob with a small thin bladed screwdriver.
3. With a small hook or long nosed pliers, remove the
switch retaining ring.
3. Remove steering wheel to gain access to turn signal
lever attaching screw. Remove screw. Remove turn
signal lever from turn signal housing utilizing the
slack in the wiring harness.
5. Push slack into turn signal lever slot at base of
lever (attachment end). This will force switch out of
the other end of the lever.
6. With a small soldering iron, unsolder the wires and
resolder them to the correct terminal of the re ­
placement switch. Use only rosin core solder.
CHEVROLET TRUCK SERVICE MANUAL