Chevrolet 10 Series 1968, Service Manual

Page: 85 / 713

BODY IB-18
[NOTE
TRIM WEATHERSTRIP
AS SHOWN. BUTT
ENDS & CEMENT TOGETHER
TUBULAR SECTION
MUST BE OPEN TO x
PROVIDE AIR PASSAGE.
VIEW B 76
6.0
±
1,0
Fig. 46 - Door Opening Weatherstrip
is made specially for weatherstrip installation, following
the manufacturer's directions. Proceed as follows:
1. Open door and block open.
2. Remove sill plate retaining screws and remove sill
plate.
3. Remove side door inner weatherstrip seal.
4. Remove used adhesive from cab door opening with
adhesive or cement remover.
5. Apply adhesive to cab opening.
6. Install molded corner of inner weatherstrip, starting
where windshield post joins the header panel.
7. Trim inner weatherstrip with a notch as shown in
Figure 46 and butt ends together.
8. Reinstall sill plate and sill plate retaining screws.
Door Trim Panel Seal Replacement
1. Remove window regulator and door remote control
handles. Handles are retained by clips.
2. Remove trim panel from door (fig. 47). Trim, panel
is retained by four seal screws.
3. Remove trim panel shown in Figure 47 and remove
used cement with cement remover.
4. Apply cement to door groove. Then start at one end
of groove applying seal.
DOOR LOCKS—10-60 SERIES
(Refer to Figs. 48, 49 and 50)
The locks are of the free rotor type. They include a
safety interlock feature. Where necessary, striker spac­
ers should be used to insure satisfactory lock and striker
engagement.
Fig.
47-
Installing Trim Panel Seal
Removal
1. Raise window.
2. Remove inside handles with Tool J-7797.
3. Remove trim panel.
4. Remove remote control sill knob.
5. From outside the door remove screws retaining lock
to door edge and lower the lock assembly.
6. Remove 3 screws retaining remote control.
7. Remove lock, push button rod and remote control rod
as an assembly.
Installation
1. Transfer remote rod with clip to new lock.
2. Connect remote door handle rod to lock after lock is
positioned.
3. Secure lock screws.
4. Secure remote handle.
5. Check all controls for proper operation before rein­
stalling trim and handles.
6. Install remote control sill knob.
Front Door Lock Cylinder Assembly
Removal and Installation
1. Raise door window and remove door trim pad.
2. With a screw driver, or other suitable tool, slide lock
cylinder retaining clip (on door outer panel) out of
engagement and remove lock cylinder.
3. To install, reverse removal procedure.
Front Door Lock Remote Control and Connecting Rod
The remote control is secured to the door inner panel
by the three attaching bolts.
Rem oval and Installation
1. Raise door window and remove door trim pad.
2„ Remove bolts securing remote to door inner panel.
CHEVROLET TRUCK SERVICE MANUAL