Chevrolet 10 Series 1968, Service Manual, Page: 286 / 713

BRAKES 5-43
V IEW B
V IE W A
V IE W C
V IEW D
C A 1 0 -2 0
V IE W A
V IEW B
C A 314
V IEW C
C A 3 0
F ig . 68—Parking Brake System C l 0 -2 0 -3 0 Series
4. Insert threaded end of adjusting bolt down between
operating cams. Position hook toward rear. As bolt
is lowered into place it must pass through band upper
bracket, upper release spring, brake support lower
release spring, and band lower bracket. Install
flat washer, adjusting nut, lock washer, and lock nut
on adjusting bolt.
NOTE:
On remote control parking brake, no
tension spring is used.
5. Turn up anchor screw “ B” (fig. 72) until there is
.010"-.015" clearance between lining and drum.
6. Draw up adjusting bolt “ C” until there is .020"
clearance between drum and lower end of band.
Tighten locknut “ D” .
7. Turn up adjusting nut “ E” until there is .020"
clearance between drum and upper end of band.
Tighten lock nut “ F” .
CHEVROLET TRUCK SERVICE MANUAL