Chevrolet 10 Series 1968, Service Manual

Page: 78 / 713

BODY IB-11
F ig . 28 - Endgate Adjustments
Hinges
If necessary to remove hinges, apply the above steps
and proceed as follows:
1. Remove four (4) bolts from each of the hinge assem­
blies on the underside of the body.
2. Remove hinge assemblies. (Note bushing positions
if disassembling to remove pin.)
3. Reverse procedure to install.
F ig . 27 - Endgate Replacement
4. Remove side endgate supports by removing pivot
bolts and washers with a 1/4" Allen head wrench.
5. While supporting the endgate in an up-right position
remove the remaining hinge bolt from each side.
(See Figure 27.)
6. Remove endgate.
7. Reverse procedure to install.
Adjustments (See Fig. 28)
Loosen bolts and adjust at either endgate hinge position
or endgate latch as shown in Figure 28.
Remote and Push Button Control Assembly
Rem oval and Installation (See Fig. 29)
1. Remove remote and push button control assembly
access cover.
2. Remove spring clip securing the right side lock rod
to remote assembly. (See Figure 30.)
F ig . 2 9 - Suburban Endgate Assembly
CHEVROLET TRUCK SERVICE MANUAL