Cambium Networks PTP 250, User Manual

Page: 166 / 228

Using the configuration wizard Chapter 6: Configuration and alignment
6-14 phn-2510_002v000 (Mar 2012)
Attribute Meaning
Use VLAN For
Management This controls whether or not the management interfaces
(WWW/SNMP/SMTP/SNTP) use VLAN tags.
Ensure that the configured VLAN is accessible, otherwise it
will not be possible to access the unit following the next
reboot.
The PTP 250 management function is only compatible with
single VLAN tagged packets. Any management packet with
two or more packets will be ignored.
Management VLAN
ID Only displayed when ‘Use VLAN for Management’ is enabled.
Enter the VLAN VID (range 0 to 4094) that will be included in
Ethernet frames generated by the management interfaces.
VLAN Priority Only displayed when ‘Use VLAN for Management’ is enabled.
Select the VLAN priority (range 0 to 7) that will be included in
Ethernet frames generated by the management interfaces.
Ethernet Auto-
Negotiation When the box is ticked, it means that configuration is
automatically negotiated. This is the default setting.
When the box is not ticked, it means that configuration is forced.
Select the data rate that the auto-negotiation mechanism will
advertise as available.
Only select a data rate that is within the capability of
connected network equipment, otherwise loss of service may
occur.
Use the same setting for both ends of the link.
The configuration should only be forced if problems are
experienced with auto-negotiation. Instead of forcing
configuration, the IEEE802.3 specification recommends enabling
Auto-Negotiation with only the specific ability or abilities
advertised.