Buffalo terastation 3000, User Manual

Page: 200 / 232

4
Select “Create a USB drive for initializing settings”.
5
From “Target USB drive”, select the USB drive that is connected to the USB 2.0 port on the TeraStation, then
click
Execute .
6
The “Confirm Operation” screen will open. Enter the confirmation number, then click OK .
7
The TeraStation will create the recovery drive. This will take about a minute. When creating the USB recovery
drive is completed, click
OK .
Dismount the USB drive before unplugging it. See the “Dismounting Drives” section in chapter 4 for the procedure
on dismounting drives.
Initializing with the USB Drive
To initialize the settings on your TeraStation with a recovery drive, follow the procedure below. If using a recovery
drive to initialize the TeraStation, you do not have to be logged in to Settings. For procedure on how to create a
recovery drive, refer to the “Creating a Recovery Drive” in chapter 1.
Note:
Initializing settings with the USB drive is available for the same TeraStation unit that created the recovery
drive.
1
Turn off the TeraStation by pressing and holding the power button for 3 seconds until it beeps.
2
Insert the recovery USB drive into a USB 2.0 port on the TeraStation. Make sure that no other USB drives are
currently connected to any USB ports on the TeraStation.
3
Set the boot mode switch to the “USB” position.
4
Press the power button to turn on the TeraStation.
5
When the I41 message appears on the LCD panel, press the function button.
6
It will take several minutes for initializing the settings. The TeraStation will shut down when it’s finished.
7
After shutdown, the I39 message is displayed.
8
Set the boot mode switch to the “HDD” position and disconnect the USB drive.
9
Press the power button to turn on the TeraStation.
199