Buffalo terastation 3000, User Manual

Page: 198 / 232

4
Click to the right of “Configuration Management”.
5
Click Browse and select the config file (.nas_config) that was created with another TeraStation.
If the config file was created with a password, enter it in the “Password” field.
6
Click Import .
7
The “Confirm Operation” screen will open. Enter the confirmation number, then click OK .
8
When transferring settings is completed, click OK .
Dismount the USB drive before unplugging it. See the “Dismounting Drives” section in chapter 4 for the procedure
on dismounting drives.
Notes:
• If the migration target TeraStation contains shared folders, users, and groups that share the same name as the
transferred settings, the existing settings will be overwritten.
• If the migration target TeraStations have already added some shared folders, users, and groups, the transferred
settings may exceed the maximum number of allowed shared folders, users, or groups. After migration finishes,
open Settings and verify that all settings were properly transferred.
Restoring Factory Defaults
There are several ways to initialize the TeraStation and restore its factory default settings. One simple way to do this
is to hold down the init button (refer to the TeraStation diagram in chapter 1) on the front panel for three seconds.
Normally this will reset the admin username and password, network configuration, SSL, and security port settings
to their factory default values. However, this button can be disabled in Settings. If the init button is disabled, refer to
the methods below on how to initialize the TeraStation.
Initializing from Settings
To initialize the TeraStation to its factory defaults from Settings, follow this procedure.
197