Bosch Rexroth lndraDrive HCS02 Series, Project Planning Manual

Page: 306 / 382

Extended Displays
Call extended displays (see also figure below):
●
initial state: standard display (e.g. "VM Lb")
● simultaneously press "Enter" and "Esc" keys for at least 8 seconds
● press "Enter" key
● press "v" or "^" key until desired display appears
● press "Enter" key
Fig.10-8: Calling extended displays
There are the following extended displays:
●
1.1 ErrBuff: error memory; with the "v" or "^" key you can browse the
memory
● 1.2 DiagBuf: diagnostic message memory; with the "v" or "^" key you can
browse the memory
● 1.3 Lfcnt: operating hours counter control section
● 1.4 Lfcnt: operating hours counter power section (only for HMV01.1R)
● 1.5 FW-***: type designation of the firmware active in the device
Setting the Language
Set language in which diagnostic message texts are displayed (see also figure
below):
●
initial state: standard display (e.g. "VM Lb")
● simultaneously press "Enter" and "Esc" keys for at least 8 seconds
296/369 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraDrive | Project Planning Manual
Operation and Diagnosis