Bosch Rexroth lndraDrive HCS02 Series, Project Planning Manual

Page: 275 / 382

connecting line
stranded wire
mm 2 16
AWG 6
tightening torque Nm 1,5 1,7
HCS03.1E-W0100, -W0150
connecting line
stranded wire
mm 2
25
AWG 4
tightening torque Nm 2,0 2,5
HCS03.1E-W0210
connecting line
stranded wire
mm 2 50
AWG 0
tightening torque Nm 8,0 9,0
HCS03.1E
voltage load
V n.s.
short circuit protection to be ensured by means of appropriate fusing elements in the
mains connection at X3
n.s. not specified
Fig.8-29: Function, pin assignment
Notes on Installation Maximum allowed line length to external braking resistor: 5 m
Twist unshielded lines.
CAUTION
Danger by insufficient installation!
Protect the lines with the appropriate fusing elements in the supply feeder.
For the connecting lines at X9, use at least the cross section of the lines for
mains connection at X3.
8.9 X13, Control Voltage (24V, 0V)
Function, Pin Assignment The external 24V supply is applied via connection point X13 for
●
the power section of the drive controller
● brake control via X6
● the control section of the drive controller with the optional modules, except
for such optional modules (e.g. safety technology S1) which require their
own power supply
Assignment Connec‐
tion
Signal name Function
4 +24V power supply and “looping
through”
3 +24V
2 0V reference potential for power
supply and “looping through”
1 0V
Spring terminal (connector)
Unit Min. Max.
Project Planning Manual | Rexroth IndraDrive Electric Drives
and Controls
| Bosch Rexroth AG 265/369
Functions and Electrical Connection Points