Bosch Rexroth lndraDrive HCS02 Series, Project Planning Manual

Page: 358 / 382

11.3.6 Mounting the Accessory HAS02
General Information
1 screw in thread XS2
2 fixing device of shielding plate
3 shielding plate
4 shield of motor cable
5 clip
Fig.11-43: Shield connection of motor cable
● Unscrew bottom or bottom left fixing screw of drive controller.
● Put fixing device of accessories to bottom of drive controller and screw
down fixing screw of drive controller again.
CAUTION
Risk of damage to the drive controller caused by too long screws!
Exclusively use the supplied screws of a length of 12 mm for the thread of the
shield connection XS2.
● Screw second screw (M6 x 12) in thread XS2 at bottom of drive controller.
● Screw shielding plate to sheet metal of accessories according to desired
cable routing of motor cable (45° or horizontal). (The figure below illus‐
trates cable routing with 45°.)
● According to diameter of motor cable, fix motor cable at corresponding
point of shielding plate (12–18 mm or 19–30 mm) with a clip. Make sure
that shield of motor cable has good contact with shielding plate (see figure
below).
348/369 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraDrive | Project Planning Manual
Accessories