Avaya Media Gateway G350, Maintenance Manual

Page: 194 / 332

Avaya Communication Manager controlled maintenance
MG-DS1 (DS1 Interface Media Module)
194 Maintenance of the Avaya G350 Media Gateway
June 2004
Table 111: TEST #140 Red Alarm Inquiry Test 1 of 4
Error
Code Test
Result
Description/ Recommendation
ABORT Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test was not received within the allowable time period.
This may be due to hyperactivity. Error Type 1538 in the error log
indicates hyperactivity. The hyperactive Media Module is out of service
and one or more of the following symptoms may be exhibited.
The MG-DS1 tests (such as Test #138 and Test #139) are aborting with
error code 2000.
The tests run on the ports of this Media Module are returning a no board
result.
A
busyout
or a
release
command has no affect on the test results.
A list config command shows that the Media Module and the ports are
properly installed.
When hyperactivity occurs, the Media Module is isolated from the system,
and all of the trunks for this Media Module are placed into the out of
service state. The system will try to restore the Media Module within 15
minutes. When no faults are detected for 15 minutes, the MG-DS1
interface Media Module is restored to normal operation. All of the trunks
for the MG-DS1 interface Media Module are then returned to the in service
state. Hyperactivity is often caused by the associated facility. In such a
case, faults (such as slips, misframes, or blue alarms) would be entered in
the error log. In addition, many hardware errors would be logged against
the associated trunk circuits. If the facility is OK and the error occurs again
after 15 minutes, replace the Media Module.
1 of 4