Avaya Cajun P580, User Manual, Page: 480 / 770

15-30 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 15
* Note: You must bring the IP interface Down to successfully
enable OSPF on the IP interface. If you do not, you
will get an error message and OSPF will not be
enabled.
CLI Commands
To use the CLI to set up an NBMA IP interface:
1. Enter Configuration mode. The CLI displays the following prompt:
(configure)#
2. Enter the following command at the prompt:
(configure)#
interface <interface-name>
The following prompt displays:
(configure-if:<interface-name>)#
3. Enter the following command at the prompt:
ip address <ip-addr> <mask>
4. Enter the following command at the prompt:
type nbma
Setting Up NBMA Neighbors
Web Agent
Procedure
To use the Web Agent to set up NBMA neighbors:
1. Open the Routing > IP > RIP or OSPF folders, whichever one was
created with an NBMA type interface.
2. Click NBMA Neighbors. The RIP or OSPF NBMA Neighbors Web
page opens.
3. Click Create. The Add NBMA RIP or OSPF Neighbor Web page opens.
4. Enter a neighbor IP interface address in the Network Address field.
5. Click CREATE, or CANCEL to restore previous setting.