Avaya Cajun P580, User Manual, Page: 156 / 770

5-22 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 5
Setting the Physical Location of the Switch
CLI Command
To set the physical location of the switch, use the following CLI command:
(configure)#
snmp-server location <server-location>
The switch displays the physical location of the switch when you enter the
show snmp command. For information on this command, see “
Viewing the
SNMP Status .”
Table 5-14 provides an explanation of the command variable.
SNMP
To set the physical location of the switch, use the sysLocation object, OID
1.3.6.1.2.1.1.6.
The complete path to this object is:
iso(1).org(3).dod(6).internet(1).mgmt (2).mib-2(1).system(1).
sysLocation(6)
Disabling or Reenabling SNMP
Disabling SNMP
To disable SNMP, use the following CLI command:
(configure)#
no snmp-server
This command overrides secure mode, which disables SNMPv1 and v2 and
enables SNMPv3. For information on secure mode, see “
Secure Mode .”
Reenabling SNMP
To reenable SNMP, use the following CLI command:
(configure)#
snmp-server enable
This command enables the three versions of SNMP: SNMPv1, v2, and v3.
Table 5-14. snmp location Command
Parameter Definition
<server-location> The physical location of the switch. The location can
range from 1 to 127 characters.