Avaya Cajun P580, User Manual, Page: 407 / 770

Document No. 650-100-700, Issue 1 12-91
Configuring IP Routing
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command
To configure LDAP settings on a primary and secondary server from the
CLI, enter the following command from configuration mode:
To change the LDAP search base, use the following CLI command.
(configure)#
ldap search-base <search-base-DN>
To change the primary LDAP server's primary ip address and port, use the
following CLI command.
(configure)#
ldap server primary <ip-addr> [<port-num>]
To change the secondary LDAP server's primary ip address and port, use the
following CLI command.
(configure)#
ldap server secondary <ip-addr> [<port-num>]
To configure policy retrieval to stop on the first error, or ignore errors, use
the following CLI command.
(configure)#
ldap execution-option {stop-on-error | ignore-
errors}
Secondary
Server Port Enter the backup LDAP server port number for the access
control list domain. The port number is used in conjunction
with the secondary server IP address. There are no special
overload values. The default port number is 389.
Search Base Enter the search criteria that will be sent to the LDAP server.
The default value is “ou=Devices, ou=AvayaPolicyManager,
o=Avaya”.
Note:
No default for the Search Base, this field is empty if
the LDAP server has not been installed:
Execution
Option Open drop-down menu and select stop-on-error or ignore-
errors. This option lets you decide if you want the policy to
continue being sent to the device, if LDAP encounters any
errors. Select stop-on-error if you want execution of the
policy to stop on the first error encountered.Select ignore-
errors if you want execution of the policy to continue even if
errors are encountered. In this case, any commands
containing errors are ignored. The default value is stop-on-
error.
Table 12-34. LDAP Configuration Dialog Box Parameters
Parameter Allows You To...
2 of 2