Avaya Cajun P580, User Manual, Page: 178 / 770

6-20 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 6
6. In the Auto Flush field, select Enable if you want to enable the auto
flush feature for the ports participating in the hunt group. The default
setting for this field is Disable.
When you enable auto flush for a hunt group, all AFT entries that were
learned on the hunt group are marked invalid if the links to all of the
hunt group ports fail. Once the AFT entries are marked invalid, they can
be learned on a redundant port. When auto flush is enabled, failover to a
redundant port occurs much sooner.
7. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Commands
Use the following CLI commands to configure a hunt group:
■
To create a hunt group, (
configure)#
set huntgroup
<huntgroup-name> [load-sharing {enable | disable}]
■
To enable or disable the auto flush feature for the ports participating
in a hunt group,
(configure)#
set huntgroup auto-flush
<huntgroup-name> {enable | disable}
Adding Ports to the Hunt Group
Once you have created and named a Hunt Group, you can add as many
additional ports as needed to the Hunt Group. The next two Hunt Group
configuration steps, adding physical ports, and switch ports to the Hunt
Group, can be done using the Web Agent or the CLI.
Web Agent
Procedure
To add ports to a hunt group using the Web Agent:
1. Select Configuration from the Modules and Ports folder on the Web
Agent window. The Module Information window opens ( Figure 6-11 ).