Avaya Cajun P580, User Manual, Page: 458 / 770

15-8 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 15
Enabling OSPF on an IP Interface
You can create an OSPF interface using either the web agent or the CLI
after you setup a VLAN and create an IP interface.
Web Agent
Procedure
After you have set up a VLAN, you must create the IP interface that your
VLAN and your subnet will use to communicate. While creating the IP
interface, you must assign it to the VLAN. The last step is to enable IP
forwarding (Routing) global parameters.
To enable OSPF on the IP interface:
1. Administratively bring down the IP interface. Select the down arrow
from the Admin. State field and select DOWN.
* Note: You must bring the IP interface Down to successfully
enable OSPF on the IP interface. If you do not, you
will get an error message and OSPF will not be
enabled.
2. Select the down arrow from the OSPF field.
3. Select Enable.
4. Administratively bring the IP interface UP.
Modifying OSPF Interfaces
You can modify the parameters on an OSPF interface using either the Web
Agent or the CLI.
Web Agent
Procedure
To modify an OSPF interface using the Web Agent:
1. In the navigation pane, expand Routing > IP > Configuration folders.
2. Click Interfaces.
The IP Interfaces Web page is displayed in the content pane.
3. Select the Select check box for the interface that you want to modify.
4. In the Admin. State column for the interface that you want to modify,
select DOWN.
This step disables the interface and must be performed before you
perform any OSPF modifications.
5. Click Apply.