Avaya Cajun P580, User Manual, Page: 183 / 770

Document No. 650-100-700, Issue 1 6-25
Using VLANs, Hunt Groups, and VTP Snooping
6. Repeat Steps 1-9 for any additional ports that you want to add to this
hunt group.
7. Repeat steps 1 through 10 on the switch at the other end of the hunt
group connection.
8. Select Configuration from the Modules & Ports folder on the Web
Agent window. The Module Information window re-opens (see
Figure 6-11 ).
9. Select a port number from the Ports column. The Physical Port
Configuration window opens (see Figure 6-12 ).
10. Select a checkbox from the Enable column for that port. The group can
now function as a load-sharing connection.
11. Click APPLY to save your changes, or CANCEL to restore previous
settings.
* Note: If thousands of addresses have been learned on a port and a link
in the hunt group goes down, the switch-over of traffic
between ports may take several seconds.
* Note: If you use static VLAN binding and hunt groups, make sure to
first bind all the VLANs to all the ports that you will use in the
hunt group and then apply the hunt group to those ports.
Viewing Hunt Group Members
You can view Hunt Group members from either the Web Agent or the CLI.
Web Agent
Procedure
To view details about hunt group members using the Web Agent:
1. Select Hunt Groups from the L2 Switching folder in the Web Agent
window. The Hunt Group Configuration window opens ( Figure 6-9 ).
2. Select a underlined number in the Members column. The Hunt Group
Members window opens with pertinent information about the members
of that hunt group (
Figure 6-15 ).