Avaya Cajun P580, User Manual, Page: 423 / 770

Document No. 650-100-700, Issue 1 13-13
Configuring Access Lists
3. Select the name of the access list to be used for filtering when IP access
control is enabled from the IP Access List field pull-down menu.
4. Click APPLY to save your changes.
CLI Command
To activate an access list using the CLI, enter the following command in
configure mode:
(configure)# access-group <access-list-name>
To disable an access list using the CLI command, enter the following
command in configuration mode:
(configure)# no access-group <access-list-name>
Example: Using an Access Control Rule to Filter
Web Traffic
To configure your switch to filter web traffic to a particular web server:
1. Select Access Lists from the Routing > IP > Configuration group on
the Web Agent window. The IP Access List dialog box displays
(
Figure 13-1 ).
2. Select Create Extended. The IP Extended Access Rule Creation
dialog box displays ( Figure 13-3 ).
3. Enter a number between 100 and 199 (or Alphanumeric) (for extended
ACL) in the Access List Name field to identify your new access control
list.
4. Enter a number in the Access Rule Index field to identify the access
rule.
5. Select Deny/Filter from the Access Type field pull-down menu.
6. Leave 0.0.0.0 and 255.255.255.255 as the Source Address and Source
Address Wildcard for the Source Subnet parameter settings. All source
traffic will match.
7. Enter the IP address in the Dest Address field that represents the
destination address of the web server. Enter a wildcard of 0.0.0.0 to
identify the specific IP address of the destination web server.
* Note: To deny/filter traffic to a specific address and not to an entire
subnet, you must specify the destination IP address of the
network node, and use a subnet wildcard of 0.0.0.0.