Avaya Cajun P580, User Manual, Page: 163 / 770

Document No. 650-100-700, Issue 1 6-5
Using VLANs, Hunt Groups, and VTP Snooping
2. Setting the VLAN Binding attribute in the Switch Port Configuration
dialog box to Bind to All should be done on links connecting two layer2
switches, where multiple VLANs span across both switches, such that
members of each VLAN are found on both sides of the link. Bind-to-all
should not be used when the switches on both ends of the link act as
routers, such that each IP subnet and each VLAN are confined to one
side of the link only and do not have members connected to the switch
at the other end. In such routing cases, the link is never used for intra-
VLAN traffic but rather is used only for traffic routed from one router to
the other. Thus, there is no need for the link to belong to multiple
VLANs, and should not be configured to bind-to-all. It should be bound
to a single VLAN that is dedicated to the connection between the two
routers. Bind-to-all in this case is not only unnecessary, but also
undesired as a lot of irrelevant broadcast/multicast traffic of other
VLANs will be sent onto this link and into the switch on the other end,
unnecessarily increasing the control-plane load on the supervisor and
increasing the chance for harmful layer3 configuration errors.
3. Setting the VLAN Binding attribute in the Switch Port Configuration
dialog box to Bind to Received. This causes the port to be bound to all
VLANs (as identified by the VLAN tag in tagged frames) received on
this port. Consequently, ports are bound to those VLANs that actually
have members that are reachable through the port.
* Note: When an untagged frame arrives on a port that is set to
Bind to ALL, it forwards the frame to the “port
VLAN”. When a tagged 802.1Q frame arrives on a
port that is set to Bind to All and the VLAN doesn’t
exist on the switch the frame is dropped.
Ingress: Untagged frames are classified to the VLAN
associated with the port on which the frame is
received. Tagged frames are classified to the VLAN
identified by the VLAN tag in the tag header of the
frame.
Forwarding: Only forward frames to the port for the
assigned VLAN.
Egress: All frames transmitted out of the port to be
tagged using the IEEE 802.1Q/Multi-Layer tag
header format. The tagged used will be that assigned
to the port.