Argantix KDC 100-100, User Manual

Page: 43 / 137

User Manual
KDC Series II DC Power Supplies 33
ENTRY DESCRIPTION
LEVEL Sets the level at which the OVP engages if OVP mode is
enabled. Use the left knob to change the OVP set level. The
level is set in percent of programmed voltage, percentage of
voltage range or absolute voltage depending on the mode.
Range is from 105 to 110 % for SVOLT mode, 0 to 110% for
RANGE mode and 0 to 1.1 x Vmax for ABS mode.
VOLT REF Sets the voltage control source to internal (INT) or external
(EXT). If external, either Voltage, current or resistance control
can be set. Available settings are:
INT Sets voltage programming to internal reference.
(Default).
EXT5V Sets voltage programming to external dc
reference. 0 - 5 V for 0 to full-scale output.
EXT10V Sets voltage programming to external dc
reference. 0 - 10 V for 0 to full scale output.
EXTRES Sets voltage programming to external resistance
mode.
CURR REF Sets the current control source to internal (INT) or external
(EXT). If external, either Voltage, current or resistance control
can be set. Available settings are:
INT Sets current programming to internal reference.
(Default).
EXT5V Sets current programming to external dc
reference. 0 - 5 V for 0 to full scale output.
EXT10V Sets current programming to external dc
reference. 0 - 10 V for 0 to full scale output.
EXTRES Sets current programming to external resistance
mode.
MODE Sets the operating mode of the supply.
CV Constant voltage mode. The supply maintains
the set voltage. If the current limit is exceeded,
the output trips off.
CC Constant current mode. The supply maintains
the set voltage as long as the load current is
below the set current limit. If the current limit is
exceeded, the output voltage is reduced to
maintain the set current level. If the load
currents falls below the set current limit, the