Argantix KDC 100-100, User Manual

Page: 123 / 137

User Manual
KDC Series II DC Power Supplies 113
Press the ENTER key to select the MIL704 main menu. One of the screens will appear as
shown in Figure 11-4. The voltage mode and setting will define which menu to select. Refer to
Section 11.2.3
Note: The user has to turn on the Output relay before starting a test and set the programmed
output voltage to a valid DC level for MIL-STD 704 testing. (27 to 29 VDC or 270 to 290 VDC). If
not, the MIL-STD 704 test mode cannot be selected.
11.2.7 Test Revision and Test Selection
If the output voltage is set for 28V DC or 270V DC the first of three MIL704 DC screens will
appear as shown in Figure 11-5. The default Revision is E. Revisions supported are D and E.
The Revision can be changed from the front panel by setting the cursor to the REV entry and
using one of the rotating knobs to scroll between D and E.
The -704 option has several menu entries spread over 3 screens as follows:
Figure 11-5: MIL704 DC Menu - 1 of 3
Figure 11-6: MIL704 DC Menu - 2 of 3
Figure 11-7: MIL704 DC Menu - 3 of 3
11.2.8 Steady State Test
Scroll to the STEADY ST MENU entry using the up and down cursor keys. Press the ENTER
key to select the STEADY STATE screen. The screen will appear as shown
Figure 11-8: Steady State DC
The MIL704 STEADY STATE screen has the following tests:
1 VOLTAGE
2 RIPPLE
The above tests can be selected by scrolling to the highlighted selection using the up and down
key and the ENTER key to start the selected test.
VOLTAGE
This test will change the output voltage for the selected phase in the following sequence: